Build any rig.
Share it with every angler.

A long mono rig for tight-line euro nymphing. A 144" butt of 20 lb Maxima Chameleon (.017") is blood-knotted to a 36" Sunset Amnesia sighter (12 lb), then an 18" transition of 12 lb Cortland mono (.013"). That runs to a 2 mm tippet ring, then 48" of 5X fluorocarbon (.006") to a #16 tungsten bead Perdigon. The thin mono butt lets you hold the line off the water and watch the sighter for strikes, and the weighted fly gets itself down without shot or an indicator.

A 10-foot wet fly leader for light 3-5 wt rods. It tapers evenly from a .019" butt through seven steps to a 22" tip of 5X at .006". The length and fine tip let a soft-hackle or wet fly sink and swing naturally on clear water.

Trey Combs' 10-foot steelhead leader for a floating line. It starts with a 72-inch .020" mono butt, then three 12-inch steps of .017", .015" and .013", and ends in 12 inches of 1X (.010") tippet. The heavy butt and short, quick steps turn over swung flies on 5 to 8 weight rods.

A simple indicator nymphing leader, 12' 11" long, for a 5-6 wt line. It starts with a 22" butt of .012" mono and 79" of 0X mono, then steps down through 20" of 3X fluorocarbon to 22" of 5X fluorocarbon. Below that is a 2 mm tippet ring and a final 12" of 5X to the fly. A 1/2" trapped-air indicator rides on the 0X, and a BB split shot sits just above the ring to get the nymph down.

Gary Borger's dead-drift dry fly leader in three sections: a stiff .013" butt, a short .010" step and a long .007" tippet, or .006" (5X) for smaller flies. Quick to tie, quick to repair on the water, and it turns a dry fly over without fuss.

Pascal Cognard's 18-foot euro nymphing leader: a long, even taper from 18 inches of .018 mono through .016, .014, .012 and 1X to a 20 inch 3X sighter of Cortland bi-color indicator mono, an 8 inch step of 5X and 79 inches of 6X. It turns over a weighted nymph on a 3-5 wt rod and keeps the fly in direct contact, with no indicator and no split shot. There's also a 7X variation; see the questions below.

A 13.5-foot euro nymphing leader that loops to the fly line. It steps down evenly through 42" each of .016", .014" and .012" mono into an 18" 3X (.008") sighter and 18" of 5X (.006") tippet. The even taper turns over a weighted nymph softly, and the fine tippet lets a small tungsten fly sink fast.

George Harvey's 9-foot wet fly leader: a short 10" butt of .017", then five 20" sections of .015", .013", .011", .009" and .008" (3X), for 9' 2" in all. The even taper turns over a wet fly or soft hackle and lets it sink just under the surface and swing across the current. It is a simple, proven leader for a single wet fly on a floating line.

A 17-foot leader for nymphing under an indicator at short range on a 3-5 wt. It steps down in 29" sections from .018" through .016", .014" and .012" to 1X (.010"), then a 23" 3X (.008") sighter and 40" of 5X (.006") tippet. A 1/2" trapped-air indicator rides on the 1X section, and a No. 4 split shot sits 10" above a size 16 bead-head nymph.

A 9-foot wet fly leader that steps down from a .019 inch butt in seven sections to 18 inches of 5X (.006 inch) tippet. The even taper turns over soft hackles and small traditional wet flies on 3-5 wt rods and lets them swing and drift with life in the current.

A 13-foot euro nymphing leader that loops to the fly line and fishes small, weighted nymphs on a tight line. It runs from 74" of .016" butt into 33" of .014" Sufix Elite, a 12" .011" transition, a 16" 3X (.008") sighter and 22" of 5X (.006") tippet. The fine tippet lets a size 16 tungsten nymph sink fast and drift naturally.

A 10-foot floating leader that tapers from .023" butt to .010" 1X tip, built for swinging and stripping flies to steelhead in rivers. The gradual seven-section taper loads the rod smoothly and turns over both heavy and light flies with precision. This is a workhorse setup for techniques that depend on line control and delicate presentation. There's also a 0X variation; see the questions below.

A 10' 5" nymphing leader built on the 60/20/20 idea: a long, stiff butt, a short taper and a fine tip. About 60 percent is butt, 49" of 30 lb and 25" of 20 lb Maxima Chameleon, 74" in all. About 20 percent is the taper, 12" each of .015" and .010" Maxima Ultragreen, 24" in all. The last 20 percent or so is the tip, 12" of 2X at .009" and 15" of 4X at .007", 27" in all. It turns over a single tungsten bead nymph and keeps contact with it in the drift.

An 11.5-foot mono leader for dead-drifting flies to salmon and sea trout in rivers. It tapers in eight even steps from 35 inches of .021" down through .019", .017", .015", .013", 0X, .011" and 1X, .010" to a 27 inch tippet of 2X, .009". The long, gradual taper lands a fly softly and lets it drift at the current's speed, the way fish see natural food in low, clear water.

A 26-foot mono nymphing leader for big trout in runs and pockets, fished tight-line with no indicator. A long .014" butt steps through .012" to a 1X sighter, then 36" of 3X fluorocarbon to a tungsten jig stonefly. The heavy fly does the sinking and the sighter shows the take, so the drift stays direct from rod tip to fly.

A straightforward 8 foot 5 inch streamer leader for 4-7 wt rods. It tapers from a .021 inch butt through four 15 inch sections, then 9 inches of .013 inch and 8 inches of 0X, to 24 inches of 2X tippet. The stout tip turns over buggers, sculpins and baitfish patterns and stands up to hard strips and strip-sets on trout.

A simple 25-foot euro nymphing leader: 211" of level .012" mono, a 42" 1X (.010") sighter and 42" of 5X (.006") fluorocarbon tippet. The thin level butt sags less than a heavy taper, so the line stays straight to a size 16 tungsten-bead nymph and small takes show on the sighter.

A 10.5-foot swing leader for salmon and steelhead on 8-10 wt rods. A 38" butt of .022" mono steps through four 13" pieces at .018", .016", .014" and .013" to a 36" tippet of .012". The stiff butt and even steps turn a swung fly over on a floating line.

Ray Bergman's 12 foot leader for nymphs and wet flies. Eight 18 inch sections of mono step down from .021" at the butt to .006" (5X) at the tip, joined with blood knots in the butt and triple surgeon's knots through the 0X, 3X and 5X pieces. It is built for one fly on a 4 to 7 weight rod. There is also a 6X variation; see the questions below.

A 15-foot dry fly leader with a long, heavy butt: 84" of .017", 12" of .012", 36" of 2X, 36" of 4X and 12" of 5X. The stout butt carries the cast and turns over larger dries in wind, while the long finer sections still let the fly land softly. It is built for 3-5 wt rods on bigger water. There's also a 6X variation; see the questions below.